Installing The Lower Unit - Yamaha E115A Service Manual

LOWR
6. Install the new O-ring q and insert car-
tridge w into the pump housing e.
q
e
c
NOTE:
Align the insert cartridge projections b with
the holes c in the pump housing.
7. Install the new O-ring r and pump hous-
ing assembly t into the lower case,
tighten the bolts y, and then install the
seal u and cover i.
Water pump housing bolt y:
18 N·m (1.8 kgf·m, 13.3 ft·lb)
cC
Do not turn the drive shaft counterclock-
wise, otherwise the water pump impeller
may be damaged.
6-19
Lower unit
A
w
b
c
6G460240
A
i
y d
u
e
t
A
r
6G460250
NOTE:
9 When installing the pump housing, apply
grease to the inside of the housing, and
then turn the drive shaft clockwise while
pushing down the pump housing.
9 Align the cover projection d with the hole
e in the pump housing.
b

Installing the lower unit

w
When installing the lower unit without
removing the power unit, be sure to sus-
pend the outboard motor. Otherwise, the
outboard motor could suddenly fall and
result in injury.
1. Align the center of the set pin a with the
alignment mark b on the bottom cowl-
ing.
61U60200
a
b
61U30230
61U5H11