Installing The Propeller Shaft Housing - Yamaha E115A Service Manual

LOWR
Drive shaft holder 6 7:
90890-06520
Pinion nut holder 8:
90890-06715
Pinion nut:
93 N·m (9.3 kgf·m, 68.6 ft·lb)
4. Install the drive shaft housing 9, and
then tighten the drive shaft housing bolt
0.
NOTE:
Apply LOCTITE 572 to the drive shaft hous-
ing bolts before installation.
Installing the propeller shaft
housing
1. Set the shift rod joint and dog clutch 1 to
the neutral position as shown.
2. Apply grease to a new O-rings, and then
install it onto the propeller shaft housing.
3. Install the washer 2 and propeller shaft
assembly 3 into the propeller shaft
housing assembly.
6-17
Lower unit
7
8
6F660310
0
9
6S360106
1
3
1
NOTE:
Face the shift rod joint connect part to
upward.
4. Install the original shim(s) 4 and pro-
peller shaft housing assembly 5 into the
lower case, and then install the straight
key 6, claw washer 7, and ring nut 8.
NOTE:
9 Be sure to select the reverse gear shim(s) if
replacing the propeller shaft housing, lower
case, or ball bearing.
9 To select the shim(s), see "Shimming".
5. Tighten the ring nut to the specified
torque.
2
61U60130
8
7
4 5 6
6G460190
9
0
6F660075
61U5H11