LOWR
2. Remove the ball bearing.
cC
Do not reuse the bearing, always replace
it with a new one.
Stopper guide plate 2:
90890-06501
Stopper guide stand 3:
90890-06538
Bearing puller assembly 4:
90890-06535
3. Remove the oil seals and needle bearing.
6
5
Needle bearing attachment 5:
90890-06653
Driver rod L3 6: 90890-06652
Checking the propeller shaft hous-
ing
1. Clean the propeller shaft housing using a
soft brush and cleaning solvent, and then
check it. Replace if cracked or damaged.
2. Check the teeth and dogs of the reverse
gear. Replace if cracked or worn.
3. Check the bearings. Replace if pitted or if
there is rumbling.
6-9
Lower unit
2
3
4
61U60060
Checking the propeller shaft
1. Check the propeller shaft. Replace if bent
or worn.
2. Measure the propeller shaft runout.
Runout limit: 0.02 mm (0.0008 in)
3. Check the dog clutch, shift rod joint, and
slider. Replace if cracked or worn.
Assembling the propeller shaft
assembly
1. Insert the large ball 1, spring 2, and
other large ball 3 into the shift slider 4.
2
1
4
S6P26200
3
61U60140
61U5H11