D-Link DWS-4000 Series Cli Command Reference page 488

D-Link Unified Switch CLI Command Reference
no session-timeout
This command sets the Telnet session timeout value to the default. The timeout value unit of time is minutes.
Format
no session-timeout
Mode Line Config
telnetcon maxsessions
This command specifies the maximum number of Telnet connection sessions that can be established. A value of 0 indicates
that no Telnet connection can be established. The range is 0-5.
Default 5
Format
telnetcon maxsessions <0-5>
Mode Privileged EXEC
no telnetcon maxsessions
This command sets the maximum number of Telnet connection sessions that can be established to the default value.
Format
no telnetcon maxsessions
Mode Privileged EXEC
telnetcon timeout
This command sets the Telnet connection session timeout value, in minutes. A session is active as long as the session has
not been idle for the value set. The time is a decimal value from 1 to 160.
Note: When you change the timeout value, the new value is applied to all active and inactive sessions
immediately. Any sessions that have been idle longer than the new timeout value are disconnected immediately.
Default 5
Format
telnetcon timeout <1-160>
Mode Privileged EXEC
no telnetcon timeout
This command sets the Telnet connection session timeout value to the default.
Note: Changing the timeout value for active sessions does not become effective until the session is reaccessed.
Also, any keystroke activates the new timeout duration.
Format
no telnetcon timeout
Mode Privileged EXEC
© 2009 D-Link Corporation. All Rights Reserved
480