Dhcp And Bootp Relay Commands - D-Link DWS-4000 Series Cli Command Reference

Authentication Type............................ None
Priority....................................... 80
Configured priority.......................... 100
Advertisement Interval (secs).................. 1
Pre-empt Mode.................................. Enable
Administrative Mode............................ Enable
State.......................................... Initialized
Track Interface
---------------
<0/1>
TrackRoute (pfx/len)
------------------------
10.10.10.1/255.255.255.0
show ip vrrp interface brief
This command displays information about each virtual router configured on the switch. This command takes no options. It
displays information about each virtual router.
Format
show ip vrrp interface brief
Modes • Privileged EXEC
• User EXEC
Term Definition
Interface Valid slot and port number separated by a forward slash.
VRID The router ID of the virtual router.
IP Address The virtual router IP address.
Mode Indicates whether the virtual router is enabled or disabled.
State The state (Master/backup) of the virtual router.
DHCP BOOTP R
AND
This section describes the commands you use to configure BootP/DHCP Relay on the switch. A DHCP relay agent operates
at Layer 3 and forwards DHCP requests and replies between clients and servers when they are not on the same physical
subnet.
bootpdhcprelay cidoptmode
This command enables the circuit ID option mode for BootP/DHCP Relay on the system.
Default disabled
Format
bootpdhcprelay cidoptmode
Mode Global Config
State DecrementPriority
------ ------------------
down
State DecrementPriority
------
down
C
ELAY OMMANDS

DHCP and BOOTP Relay Commands

10
------------------
10
187