Suzuki sq-416-420-625 Service Manual page 795

ACTIVATION INSIDE VEHICLE
Use this procedure when scrapping the entire vehicle including the seat belt pretensioners.
CAUTION:
When vehicle itself will be used again, activate pretensioner outside vehicle according to "Activation
Outside Vehicle", for activating it inside will cause the center pillar inner garnish and their vicinity to
be deformed.
Failure to observe this CAUTION may require unneeded vehicle inspection and repair.
WARNING:
Following precautions must be observed for this work. Failure to observe any of them may result in
personal injury.
D To avoid an accidental activation, this work should be performed by no more than one person.
D The procedure should be followed strictly as described here.
D Be sure to read "Service Precautions" for the seat belt pretensioner beforehand.
D Never connect deployment harness to any power source before connecting deployment harness to
the seat belt pretensioner. Deployment harness shall remain shorted and not be connected to a power
source until the pretensioner is to be activated.
D The seat belt pretensioner will immediately activate the pretensioner when a power source is con-
nected to it. Wear safety glasses throughout this entire activation and disposal procedure.
D Wear suitable ear protection when activating pretensioner. Also, advise those who are in the area
close to activation site to wear suitable ear protection.
D Do not activate driver and passenger seat belt pretensioners at the same time.
For driver side
1. Air bag harness
2. Seat belt pretensioner harness
1) Turn ignition switch to "LOCK", remove key and put on safety
glasses.
2) Remove all loose objects from front seats and instrument panel.
3) Remove both side (driver and passenger side) front pillar lower
trims and disconnect seat belt pretensioner harnesses from air
bag harness.
4) Confirm that each seat belt pretensioner is securely mounted.
AIR BAG SYSTEM 10B-89