Suzuki sq-416-420-625 Service Manual page 493

7C1-12 CLUTCH
2
1
1
"A", (a)
1. Flywheel
2. Bolt
(C)
1. Clutch cover
INSTALLATION
NOTE:
Before assembling, make sure that flywheel surface and pres-
sure plate surface have been cleaned and dried thoroughly.
1) Install flywheel to crankshaft and tighten bolts to which sealant
is applied to specification.
Special Tool
(A): 09924-17810
"A": Sealant 99000-31110
Tightening Torque
.
(a): 78 N m (7.8 kg-m, 56.5 lb-ft) (G16 engine)
.
(a): 70 N m (7.0 kg-m, 50.5 lb-ft) (J20 and H25 engines)
2) Using special tool (B), install input shaft bearing to flywheel.
Special Tool
(B): 09925-98210
3) Aligning clutch disc to flywheel center by using special tool (C),
install clutch cover and bolts. Then tighten bolts to specification.
NOTE:
D While tightening clutch cover bolts, compress clutch disc
with special tool (C) by hand so that disc centered.
D Tighten cover bolts little by little evenly in diagonal order.
Special Tools
(A): 09924-17810
(C): 09923-36330 (G16 engine)
(C): 09923-36320 (J20 and H25 engines)
Tightening Torque
.
(b): 23 N m (2.3 kg-m, 16.5 lb-ft)