Suzuki sq-416-420-625 Service Manual page 216

3D-14 FRONT SUSPENSION
OK
2) Install new sensor rotor by using special tool (if equipped with
ABS).
NOTE:
Use care not to insert wheel hub diagonally.
Special Tool
(A): 09952-86510
(B): 09924-74510
Wheel speed sensor rotor installing position
Reference Dimension "a" : 4.9 8 0.1 mm (0.19 8 0.004 in.)
1. Sensor rotor
2. Wheel hub
3. Hydraulic press
3) Install wheel hub component to spindle supporting wheel bear-
ing inner race by finger as shown.
NG
NOTE:
When it is impossible to install wheel hub component by
1. Wheel hub
hand, which means the inner race is out of alignment, re-
2. Wheel spindle
3. Bearing inner race
move wheel hub component once and reinstall it.
4) Install wheel bearing washer, and the install wheel bearing lock
nut.
5) Tighten wheel bearing lock nut to specified torque while turning
wheel hub by hand.
Special Tool
(A): 09951-16050
Tightening Torque
(a): 216 N
6) Using lock washer, lock bearing lock nut. If lock screw hole is not
aligned with screw hole in lock nut, turn lock nut in tightening
direction till they align.
Tightening Torque
(b): 1.5 N
1. Lock washer
CAUTION:
Don't tap wheel hub component by hammer or the like.
Otherwise, it will be broken.
.
m (21.6 kg-m, 157 lb-ft)
.
m (0.15 kg-m, 1.1 lb-ft)