Suzuki sq-416-420-625 Service Manual page 393

7A-10 MANUAL TRANSMISSION (TYPE 1)
1. Transmission jack
2. Engine rear mounting member
ON LIFT
1) Drain oil from transmission and transfer.
2) Give match marks on joint flange and propeller shaft as shown
3) Remove flange bolts of rear propeller shaft universal joint and
4) Remove flange bolts of front propeller shaft universal joint and
5) Remove clutch operating cylinder from transmission. It is not
1. Match mark
6) Remove clutch housing lower plate.
1. Flange bolt
2. Front propeller shaft
7) Disconnect couplers from 4WD switch, back up light switch and
8) Apply transmission jack and remove engine rear mounting
9) After removing mounting member, move rearward transmission
in figure. (front and rear)
pull out propeller shaft.
pull out propeller shaft.
necessary to disconnect clutch hose from operating cylinder.
NOTE:
D It is not necessary to drain transmission oil when dis-
mounting transmission and transfer for clutch mainte-
nance only.
D Work without draining transfer oil is possible if front pro-
peller shaft is dismounted together with transmission and
transfer.
speed sensor assembly and release their harness from clamps.
Remove nuts from joint with engine.
member taking off its bolts.
and transfer assemblies placed on jack and then lower them.