Suzuki sq-416-420-625 Service Manual page 47

0B-20 MAINTENANCE AND LUBRICATION
Type 1
1. Drain plug (Apply sealant)
2. Reverse idle gear shaft bolt (DO NOT LOOSEN IT)
3. Filler / level plug (Apply sealant)
Type 2
ITEM 6-10
Manual Transmission Oil Inspection and Change
Inspection
1) Inspect transmission case for evidence of oil leakage.
2) Make sure that vehicle is placed level for oil level check.
3) Remove level plug of transmission.
4) Check oil level.
5) Tighten level plug to specified torque.
Change
Change transmission oil with new specified oil referring to Section
7A or 7A1.
1. Drain plug
2. Filler / level plug
ITEM 6-11
Automatic Transmission Fluid Inspection and Change
Inspection
1) Inspect transmission case for evidence of fluid leakage.
2) Make sure that vehicle is placed level for fluid level check.
3) Check fluid level.
1. Level gauge
2. FULL HOT mark
3. LOW HOT mark
4. FULL COLD mark
5. LOW COLD mark
Repair leaky point if any.
Oil level can be checked roughly by means of level plug hole.
That is, if oil flows out of level plug hole or if oil level is found up
to hole when level plug is removed, oil is properly filled.
If oil is found insufficient, pour specified amount of specified oil.
Refer to Section 7A or 7A1 for installation and tightening torque.
Repair leaky point, if any.
For fluid level checking procedure, refer to On-vehicle service in
Section 7B1 and be sure to perform it under specified conditions.
If fluid level is low, replenish specified fluid.