Siemens HiPath 1100 Service Manual page 288

Operation
System programming mode using a PC
To perform HiPath 1100 administrative tasks on a computer using an optiPoint interface, you
must first install the appropriate USB drivers for optiPoint, according to the connection to be
used (see Chapter 7, "optiPoint USB drivers" ) and start installing the applications HiPath 1100:
Procedure:
1. Insert the HiPath 1100 CD in the CD drive
If Auto-Run is not configured, go to the Windows Start menu, click Run and then select the
Browse button in the dialog box. Open the SETUP.EXE file on the CD drive.
2. In the Setup window, select the language you want to use.
Once the language has been selected, all corresponding country-specific settings will be
established.
3. A window will appear where you can select the software to be installed
4. Select the software components you wish to install and install them. For programming the
HiPath 1100 system, the following applications must be installed:
HiPath 1100 Manager
●
CommServer (installs automatically).
●
5. After each component is installed, a message is displayed indicating that the installation
was completed successfully. Click "Next" every time it appears
6. Click "Finish" to close the installation window. This completes the software installation.
Windows may display a message to restart the computer. If this occurs, restart the
computer.
7. After installation is completed, configure the Communication Server (see Figure 7-6).
Right-click the CommServer icon on the Windows status bar and select "Properties":
7-288
Service Manual