Configuring The System Specifically For The Client; Numbering Plan; Table 6-1 Configuration Procedure Summary; Table 6-2 Detection Sequence Of The Modules - Siemens HiPath 1100 Service Manual

6

Configuring the system specifically for the client

Procedure Summary
Step System Telephone/Standard MF Telephone
1. System programming can only be executed using the
system's first extension slot (analog extension (MF) or
system telephone).
2. Programming Mode: *95 + PASSWORD (default: 31994). Configure CommServer.
3. Valid parameter or code: beep (Brazil).
4. When an incorrect setting is entered: 3 beeps (Brazil).
5. When completed: 1 beep (Brazil).
6. End programming: press "#" key or replace handset.
Table 6-1 Configuration procedure summary
6.1

Numbering Plan

The Numbering Plan is configured based on the modules detected by the system.
Detection
1.
2.
3.
4.
Table 6-2 Detection sequence of the modules
Service Manual
Configuring the system specifically for the client
HiPath 1120
Motherboard
S module
0
Analog modules
Connect the PC to the
system.
Start the program.
System data are
automatically imported.
Start programming.
Export the new
configuration settings.
HiPath 1150
TME1 module 1
Motherboard
S module
0
Analog modules
Numbering Plan
HiPath 1100 Manager
HiPath 1190
Analog modules
TME1 module 1
S module
0
6-205