Siemens SINUMERIK 840D Operator's Manual page 81

09.01
© Siemens AG, 2001. All rights reserved
SINUMERIK 840D/810D Configuring the OP 030 Operator Interface (FBO) – 09.01 Edition
•
Start the text makefile with
<Project> -> <Build> TXT_PJ_G. Alternatively, initiate the
command "nmake" in the \proj\text\g catalog .
•
The compilation is successful if the following message appears in
the output window:
...
MAKEFILE - 0 error(s), 0 warning(s)"
•
Select <Project> -> <Open> to open the project
L:\proj\app\obj_c800\app.mak. Alternatively, open the file using a
standard DOS editor.
•
Open the file app.c by clicking the icon "Open a file of the current
Project" (top left).
•
Search for the symbolic text identifier "T_PJ_DUMMY".
•
Change the symbolic text identifier:
"TEXT (101, X_T_APP, Y_T_APP+15, T_PJ_HELLO, CS_SMALL,
0, WHITE)".
This outputs the text "T_PJ_HELLO" on the screen.
•
Start the compilation for the application configuration with
<Project> -> <Build> APP.LIB. Alternatively, initiate the command
"nmake" in the \proj\app catalog .
•
The compilation is successful if the following message appears in
the output window:
"APP.LIB - 0 error(s), 0 warning(s)"
•
Select <Project> -> <Open> to open the makefile
L:\proj\dat\makefile to link the binary configuration file proj.dat.
•
Start the linking process for the binary configuration file with
<Project> -> <Build> PROJ_DAT. Alternatively, initiate the
command "nmake" in the \proj\ catalog .
•
The link is successful if the message which appears in the output
window has the following ending:
"...
Make Complete.
MAKEFILE - 0 error(s), 2 warning(s)"
Development Kit (EU)
3 First Steps in Configuring
EU/3-27