Siemens SINUMERIK 840D Operator's Manual page 162

Introduction to Configuring (PSE)
6 Sequence for Configuring the MMC 100/HMI Embedded
Compile application
Link application
Test application in
simulation
Transfer application
to hardware
Create disks
PSE/6-34
++
Microsoft Visual C Workbench
1. "Project" menu
2. Build or Rebuild project
•
<Build> only compiles changed application source files again
•
<Rebuild All> compiles all application source files, irrespective
of whether they have been changed or not
++
Microsoft Visual C Workbench
1. TOOLS menu
2. "Generate SL.DAT"
++
Microsoft Visual C Workbench
1. TOOLS menu
2. Start "PC Simulation"
++
Microsoft Visual C Workbench
1. TOOLS menu
2. "Installation Kit"
•
Direct route:
"Install System Software via RS-232-C" menu
•
Indirect route:
via disk
++
Microsoft Visual C Workbench
1. TOOLS menu
2. "Installation Kit"
•
System disk (with basic system)
•
Application disk
•
Text disk
SINUMERIK 840D/810D Configuring the OP 030 Operator Interface (FBO) – 09.01 Edition
© Siemens AG, 2001. All rights reserved
09.01
▄