Set Controller-Date - HP P2000 G3 Cli Reference Manual

set controller-date

Description Sets the date and time parameters for the system. You can set the date and time manually or
configure the system to communicate with a Network Time Protocol (NTP) server. Alternatively, you
can configure NTP by using the
NOTE:
command, the NTP parameters will take precedence. If the NTP server cannot be contacted, the date
and time will not be changed and no error message will be displayed.If you specify the timestamp
parameter and other manual date/time parameters in the same command, the timestamp
parameter will take precedence.
Syntax To set the date and time manually:
set controller-date
jan|feb|mar|apr|may|jun|jul|aug|sep|oct|nov|dec
day
hh:mm:ss
year
To set the date and time manually by specifying a timestamp:
set controller-date
timestamp timestamp
timezone +|-hh[:mm]
To configure use of NTP:
set controller-date
ntp enabled|disabled|on|off
ntpaddress IP-address
timezone +|-hh[:mm]
Parameters jan|feb|mar|apr|may|jun|jul|aug|sep|oct|nov|dec
The month.
day
The day number (1–31).
hh:mm:ss
The hour (0–23), the minutes (0–59), and the seconds (0–59).
year
The year as a four-digit number.
ntp enabled|disabled|on|off
Enables or disables use of NTP. When NTP is enabled and the specified NTP server is available,
each controller's time is synchronized with the server.
ntpaddress IP-address
The network address of an available NTP server.
timezone +|-hh[:mm]
The system's time zone as an offset in hours (- 1 to - 1 2, +1 to +13) and minutes (0–59) from
Coordinated Universal Time (UTC). For example, the Pacific Time Zone offset is -8 during Pacific
Standard Time or -7 during Pacific Daylight Time.
timestamp timestamp
The date and time represented as the number of seconds (not counting leap seconds) that have
elapsed since 1970-01-01 00:00:00 UTC. The resulting time will be in UTC, unless you also specify
the timezone parameter.
144 Alphabetical list of commands
set ntp-parameters
If you specify valid NTP parameters and manual date/time parameters in the same
command.