GE NX-10 Installation Manual page 54

Segment 3
Segment 4
Segment 5
•
Maglock/Drop Bolt: When a door zone is programmed and this option is checked, then the
relay output uses the different kind of logic for setting the lock. To prevent a door from
slamming shut due to a maglock or from not getting shut at all with a premature lock of a
drop bolt, the reader monitors the door zone and waits for the door to be shut for a couple of
Enabling the Schedules for the Onboard Relay Output
On if relay output follows Schedule 1.
1
On if relay output follows Schedule 2.
2
On if relay output follows Schedule 3.
3
On if relay output follows Schedule 4.
4
On if relay output follows Schedule 5.
5
On if relay output follows Schedule 6.
6
On if relay output follows Schedule 7.
7
On if relay output follows Schedule 8.
8
Door Options
On if locking mechanism is a Maglock or Drop Bolt.
1
On if access is allowed regardless of Armed status of the system.
2
No Unlock Latch. On if the door is not to be latched unlocked during an open schedule.
3
On if onboard relay output only triggers during an open schedule.
4
On if onboard relay output only triggers during a close schedule.
5
On if Forced Entry Alarm is logged.
6
On if access allowed without an RTE.
7
No armed Egress. On if the Egress input is to be disabled while the ProxPad partition is
8
armed.
Door Options (cntd..)
"On" when relay operation is inverted.
1
Disable relay operation when the ProxPad partition is disarmed.
2
Reserved.
3
Reserved.
4
Reserved.
5
Reserved.
6
Reserved.
7
Reserved.
8