Table of Contents
Advertisement
List of Functions
Sub-menu
IP Settings
(This can be set only if Connection Mode is set to Advanced.)
You can make network settings.
DHCP: Set to On to make network settings using DHCP
is set to On, you cannot set any more addresses.
IP Address: You can input the IP address
projector. You can enter a number from 0 to 255 in each field of
the address. However, the following IP addresses cannot be used.
0.0.0.0, 127.x.x.x, 224.0.0.0 to 255.255.255.255 (where x is a
number from 0 to 255)
Subnet Mask: You can input the subnet mask
You can enter a number from 0 to 255 in each field of the address.
However, the following subnet masks cannot be used.
0.0.0.0, 255.255.255.255
Gateway Address: You can input the IP address for the gateway
for the projector. You can enter a number from 0 to 255 in each
field of the address. However, the following Gateway addresses
cannot be used.
0.0.0.0, 127.x.x.x, 224.0.0.0 to 255.255.255.255 (where x is a
number from 0 to 255)
SSID Display
To prevent the SSID
screen, set this to Off.
To prevent the IP address
IP Address Dis
Standby screen, set this to Off.
play
Function
g
. If this
g
assigned to the
g
for the projector.
g
from being displayed on the LAN Standby
g
from being displayed on the LAN
Security menu
g
Sub-menu
Select the security type from the items that are displayed.
Security
When setting security, follow the instructions from the
administrator of the network system you are about to access.
WEP Encryption
You can set the encryption method for WEP encryption.
128Bit: Uses 128 (104) bit encoding.
64Bit: Uses 64 (40) bit encoding.
You can set the input method for the WEP encryption key to
Format
ASCII or HEX.
You can select the WEP encryption ID key.
Key ID
87
Function
Advertisement
Table of Contents
