Problem Solving
Check
Is the Control Panel Lock set to Full Lock?
Is the remote receiver set correctly?
Problems Relating to the Easy Interactive Function
Cannot use the projector's drawing function
Check
Has pen calibration been performed correctly?
Is Pen Mode set to PC Interactive?
Cannot operate as a mouse and draw by connecting to a computer
Check
Is Extended set correctly?
The projector is not correctly connected to the computer.
If you are using a notebook computer when the battery power is
running low, the USB port may stop working and you might not be
able to use USB devices.
Press the [t] button on the remote control. If you do not want to use Control Panel Lock, change the setting to Off.
s Settings - Control Panel Lock
p.79
Check the Remote Receiver from the Configuration menu.
s Settings - Remote Receiver
p.79
Make sure you perform pen calibration when using the Easy Interactive Pen for the first time so that the projector
recognizes the position of the pen correctly.
Also, calibrate the pen again if you notice any discrepancy in positioning.
s "Auto Calibration"
p.47
Set Pen Mode to PC Free Annotation from the Configuration menu.
s Extended - Easy Interactive Function - Pen Mode
Make the following settings to link with the computer's functions.
• Set Extended - USB Type B to Easy Interactive Function or USB Display/Easy Interactive Function from the
Configuration menu.
• Set Pen Mode to PC Interactive from the Configuration menu.
s Extended - Easy Interactive Function
Check the USB cable connections. You may be able to resolve the problem by disconnecting and then reconnecting the
USB cable.
Connect the computer to a power source.
Remedy
Remedy
p.80
Remedy
p.80
106