ABB -i-Bus-KNX Millenium Technical Reference Manual page 46

KNX Technical Reference Manual
®
ABB-i-Bus -KNX Millenium
Additional parameters for "Control
function = Heating"
Control parameter
Type of heating system
P amount heating (1/10 K)
I-component heating (min.)
max. control value heating
min. control value heating
Additional parameters for "Control
function = Cooling"
Control parameter
P amount cooling (1/10 K)
I-component cooling (min.)
max. control value cooling
min. control value cooling
Note
The following parameters are available only when parameter "Control type heating" or "Control
type cooling" is set on "PI continuous", or "FanCoil".
Additional parameters for "Control
function = Heating"
Control value difference PI continuous for
sending of the control value heating
Additional parameters for "Control
function = Cooling"
Control value difference PI continuous for
sending of the control value cooling
KNX Technical Reference Manual | 1473-1-7819
Settings
• via system type
• Free paramaterization
For "PI continuous" • Hot-water heating
and "PI PWM (1-bit)" • Electric heating
(1.5 K/50 min)
• Floor heating (4
K/200 min)
For "FanCoil" FanCoil (4 K/90 min)
10 ... 100
0 ... 255
0 ... 255
0 ... 255
Settings
• via system type
• Free paramaterization
10 ... 100
0 ... 255
0 ... 255
0 ... 255
Settings
• deactivated
• 2 %
• 5 %
• 10 %
Settings
• deactivated
• 2 %
• 5 %
• 10 %
Description of applications /
Comments
–
Type of heating system
Only available when parameter "Control
parameter" is set on "Free
paramaterization".
–
–
Comments
–
Only available when parameter "Control
parameter" is set on "Free
paramaterization".
–
–
Comments
–
Comments
–
objects
— 46 —