KNX Technical Reference Manual
®
ABB-i-Bus
-KNX Millenium
Note
The following parameters are available only when parameter "Control type heating" is set on "PI
continuous", or on "FanCoil".
Additional parameters for "Control
function = Heating"
Control value difference PI continuous for
sending of the control value heating
Note
The following parameters are available only when parameter "Control type heating" is set on "PI
continuous", or on "PI PWM (1-bit)".
Additional parameters for "Control
function = Heating"
PWM cycle heating (min)
KNX Technical Reference Manual | 1473-1-7819
Settings
• deactivated
• 2 %
• 5 %
• 10 %
Settings
1 ... 60
Description of applications /
Comments
–
Comments
–
objects
— 33 —