Siemens Gigaset S685 IP User Manual page 86

If you accept an incoming call, the room
monitor is suspended for the duration of
the call, but the function remains acti-
vated.
If you deactivate then re-activate the
handset, the room monitor remains acti-
vated.
Warning!
– You should always check the operation
of the room monitor before use. For
example, test its sensitivity. Check the
connection if you are diverting the room
monitor to an outside number.
– When the function is switched on, the
handset's operating time is considerably
reduced. If necessary, place the handset in
the charging cradle. This ensures that the
batteries do not run down.
– Ideally the handset should be positioned 1
to 2 metres away from the baby. The micro-
phone must be directed towards the baby.
– The connection to which the room monitor
is forwarded must not be blocked by an
activated answer machine.
Activating the room monitor and
entering the number to be called
¢ ¢
v í
Room Monitor
¤
Change multiple line input:
Room M.:
Select to activate.
On
Call to:
External number:
¤
Select the number from the direc-
tory (press display key
enter it directly. Only the last 4
characters are displayed.
Internal number:
¤
Press the display key
Select and press
INT
¤
Use s to select the handset or
All (if all registered handsets are to
be called) and press
Level:
Set noise level sensitivity
¤
Save changes (page 147).
The function is now activated.
Ò
) or
.
§Options§
.
§OK§
Call
.
§OK§
(Low or High).
You can use the
§Options§
switch directly to the baby alarm settings.
Please note:
If you do not specify a line suffix (page 27) and
you do not define any dialling plans for the
number (page 124), an external number will
be dialled via the set standard connection
(VoIP or fixed line network).
Changing the set destination number
¢ ¢
v í
Room Monitor
s
Scroll to the
X
or
§Delete§
Delete existing number.
¤
Enter number as described in "Activat-
ing the room monitor and entering the
number to be called" (page 85).
Deactivating the room monitor
remotely
Precondition: The room monitor call is
sent to an external destination number.
The telephone called supports touch tone
dialling.
¤
Accept the call from the room monitor
and press keys 9 ;.
Your base station sends a confirmation
tone and ends the connection.
Please note:
External deactivating via VoIP connections is
possible as long as the DTMF signals are trans-
mitted (depending on the provider) either as
SIP info messages, audible signals in the voice
channel (inband or audio) or as special RTP
data packets (pursuant to RFC2833).
The room monitor function is deactivated
on the handset. There will be no further
room monitor calls. The other room moni-
tor settings (e.g. no ringer tone) on the
handset will remain activated until you
press the display key
To re-activate the room function with the
same phone number:
¤
Turn on the activation again and save
with (page 85).
§Save§
Using several handsets
display key to
Call to: line.
on the handset.
§OFF§
85