Assembling The Forward Gear; Assembling The Drive Shaft Housing; Installing The Drive Shaft - Yamaha F200C Service Manual

LOWR
2. Install the needle bearing outer case into
the lower case.
È
NOTE:
Apply engine oil to the needle bearing outer
case before installation.
Needle bearing installer 3:
YB-06435
Pinion gear bushing installer 4:
YB-06029-4
Needle bearing remover and installer
5:
YB-06213
3. Install the needle bearing into the needle
bearing outer case.
NOTE:
Apply engine oil or grease to the needle
bearing, and then install it.

Assembling the forward gear

1. Install the new taper roller bearing into
the forward gear using a press.
È
Forward gear bearing cup installer
1:
YB-06276-B
6-19
Lower unit

Assembling the drive shaft housing

1. Install the needle bearing into the drive
shaft housing to the specified depth.
Needle bearing installer and remover
1:
YB-06194
Driver handle 2: YB-06071
Depth a:
4.25–4.75 mm (0.167–0.187 in)
2. Apply grease to the new oil seals, and
then install them into the drive shaft
housing to the specified depth.
È
NOTE:
Install an oil seal halfway into the drive shaft
housing, then the other oil seal.
Oil seal installer 3: YB-06195
Driver handle 4: YB-06071
Depth b:
0.25–0.75 mm (0.01–0.03 in)

Installing the drive shaft

1. Install the forward gear to the lower case.
69J1D11