LOWR
Removing the drive shaft
1. Remove the drive shaft, drive shaft hous-
ing, and pinion, and then pull out the for-
ward gear.
È
Drive shaft holder 1: YB-06201
Disassembling the drive shaft
housing
1. Remove the cover, oil seals, and needle
bearing.
Drive shaft needle bearing remover
and installer 1:
YB-06196
Driver handle 2: YB-06071
6-17
Lower unit
Disassembling the forward gear
1. Remove the taper roller bearing from the
forward gear using a press.
CAUTION:
Do not reuse the bearing, always replace
it with a new one.
Bearing splitter plate 1:
(commercially obtainable)
Disassembling the lower case
1. Remove the taper roller bearing outer
race and shim(s).
È
NOTE:
Install the claws as shown.
Slide hammer and adapters 1:
YB-06096
Puller claw 2: YB-06523
2. Remove the needle bearing.
S69J6186
69J1D11