Yamaha F200C Service Manual page 156

POWR
6. Install half of the bearings 9 into the cyl-
inder block 0.
7. Insert the projection f of the bearing into
the notch in the cylinder block.
E
NOTE:
Install the main bearings in their original posi-
tions.
8. Set the crankshaft A, and oil seal B,
and thrust bearings C into the cylinder
block as shown.
NOTE:
Apply engine oil to the inner oil seal and the
thrust bearings before installation.
9. Install half of the bearings D and the
thrust bearing E into the crankcase.
NOTE:
Install the main bearings in their original posi-
tions.
5-57
Power unit
S69J5F10
10. Apply sealant to the mating surface of
the crankcase.
11. Insert the projection g of the bearing into
the notch in the crankcase.
NOTE:
Do not get any sealant on the journal bear-
ings.
12. Install the crankcase onto the cylinder
block, and then tighten the crankcase
bolts to the specified torques in two
stages and in the sequence shown.
CAUTION:
Crankcase bolts 1–F can be reused five
times.
69J1D11