Panasonic KX-TD1232 Program Manual page 81

Programming
1.
Enter 114.
Display: 114 VM DTMF CMD
2. Press NEXT to program the LV-MSG command.
To program another command, keep pressing NEXT until the desired command is
displayed.
Display example: LV-MSG:H
3. Enter a DTMF signal number.
To delete the current entry, press CLEAR.
To change the current entry, press CLEAR and enter the new number.
4. Press STORE.
5. To program another selection, keep pressing NEXT or PREV until the desired selection is
displayed.
6.
Repeat steps 3 through 5.
7.
Press END.
Conditions
• A command signal number can have a maximum of 16 digits, consisting of 0 through 9,
,#, FLASH or FLASH/RCL and PAUSE.
• The FLASH or FLASH/RCL button is available only for LV-MSG and GETMSG
commands to store "H" which means "Home Position".
• If "H" is stored for "LV-MSG", a mailbox number programmed in program [609] Voice
Mail Access Codes or an extension number will be sent to the VM port (Follow On ID
function). If certain codes are required before and after the ID code, insert "H" between the
codes, as "aaaHbbb". If nothing is stored, it will operate as "H".
• If " H" is stored for "GETMSG", a mailbox number programmed in program
[609] Voice Mail Access Codes or an extension number will be sent to the port succeeding
the " ".
Features Guide References
Voice Mail Integration
Programming Guide
General Programming
81