Panasonic KX-TD1232 Program Manual page 16

General Programming Instructions
Going to another program address
After pressing STORE, you can go to another program with either of the following two
methods:
a) To go to the next larger program address:
Press Soft 1 (SKP+) or VOLUME
To go to the next smaller program address:
Press SHIFT + Soft 1 (SKP—) or VOLUME
b)
To go to a specific program address:
Press END, then enter the Program Address.
Method (1) is useful when you want to perform a series of programs consecutively. For
example, to change the programming in addresses [000] to [008], use this method. You can
move from [000] to [001], from [001] to [002], and so on by pressing the SKP+ or VOLUME
. You can move in reverse order from [008] to [007], etc. by pressing the SKP— or
VOLUME .
This method can also be used to move between neighboring program groups: For example,
you can move between the program addresses [008] and [100], [116] and [200], and so on.
Also, you can move between the smallest program address [000] and the largest one [991].
Method (2) is useful when you wish to jump to another program address. For example, you
have just finished with program [006] and now you want to go to program [301]. Neither SKP+
/ VOLUME
and enter 301.
Note
The following programming instructions assume that you have already entered the
programming mode and that you will use Method (2).
Confirming the entries
You may review the stored programming without making any changes.
Going back to the operation mode
Two ways are available to go back to the operation mode:
a) Lift the handset while in programming mode.
b) When the Initial Message: SYS-PGM NO? is displayed, press the PROGRAM (or
PAUSE) button. (To display the Initial Message, press END.)
16
nor SKP— / VOLUME
(DOWN).
(UP).
is convenient in this case. So you should press END
Programming Guide