Table of Contents
Advertisement
⑤ Insert one end of the LCD panel connection cable into the connector at the position shown in the
diagram.
⑥ Check that the forced bypass switch Forced Bypass above the connector is set to the "Inverter" side.
⑦ Insert the other end of the cable connected in step ⑤ into the connector on the back of the front panel.
⑧ Secure the front panel with screws in two places on the left and right.
⑥ Is the switch set to the
"Inverter" side?
⑧ Use a screwdriver to
tighten the screws in two
places on the left and right
to secure the front panel.
⑤ Insert one end of the
connection cable into
the connector.
⑦ Check the insertion orientation of
the connector.
The connector cannot be inserted
if it is not oriented properly.
Installation and Wiring
Back of Front Panel
18
Advertisement
Table of Contents
