Mounting Methods; Ordering Data - ABB RER601 Product Manual

Wireless Gateway
RER601/603
Product version: 1.2
Table 10. RoHS and REACH compliance
Description
Complies with RoHS directive 2002/95/EC
Complies with REACH directive 2006/1907/EC

6. Mounting methods

The devices have been equipped with mounting
arrangements that are specially designed to enable wall or
rack mounting inside the control cabinets. A set of DIN rail
mounting clips, included with the devices, are recommended
to be used when mounting. The specific mounting position is
dependent on the intended application of the device,
preferably inside a robust, weatherproof control cabinet.
As the device uses GPRS radio waves for data transmission,
the surrounding environment can negatively affect the efficacy
of these radio signals. Therefore, if you are using a device
with the antenna mounted directly attached to the antenna
connector (device with standard antenna without optional
extension cable), try to avoid placing the unit in a location
where the radio signal might be shadowed, and therefore
deteriorated by nearby obstacles or enclosures.
Note also that large metallic surfaces, racks or walls with
metallic structures (cabling, concrete iron, etc.) may degrade
the antenna performance to a very high extent. In this case it
is highly recommended to use the optional external antenna
14
with appropriate cable. This allows for better positioning of
the devices, antennas and thus optimal performance.
Another restriction to the positioning of the device, when
installing it, is that it should be mounted in such a way that
the required environmental conditions that are set in the
Technical Data section of this Product Guide would also be
met.

7. Ordering data

Product label is found on the bottom of the device and it
contains the basic information about the unit such as product
name, serial number and Ethernet MAC address.
The order number consists of a string of codes generated
from the device's hardware and software modules. Use the
ordering key information to generate the order number when
ordering complete devices.
As an example of how the ordering code is generated the
following schematics are shown.
1MRS757424 C
ABB