ABB RER601 Product Manual

Wireless gateway
Hide thumbs Also See for RER601:

Advertisement

Quick Links

Wireless Gateway
RER601/603
Product Guide

Advertisement

Table of Contents
loading

Summary of Contents for ABB RER601

  • Page 1 Wireless Gateway RER601/603 Product Guide...
  • Page 2: Table Of Contents

    Disclaimer The information in this document is subject to change without notice and should not be construed as a commitment by ABB. ABB assumes no responsibility for any errors that may appear in this document. Drawings and diagrams are not binding.
  • Page 3: Description

    Issued: 2014-08-18 Revision: C 1. Description This means that the Wireless Gateway RER601/603 can be Wireless Gateway RER601/603 provides wireless monitoring utilized for various industrial applications to maximize the and control of field devices via GPRS from a central site or following benefits: control center.
  • Page 4: Applications

    RER601/603 Product version: 1.2 2. Applications • Secure communication maintained with internal VPN and The Wireless Gateway RER601/RER 603 can be used in most Firewall feeder automation and wireless substation applications • Mobile operator independent static IP addressing with an...
  • Page 5 The LED panel of the device contains ten LEDs which are used to indicate the complete operational status of the The Wireless Gateway RER601/603 also has two serial ports device. The LEDs are numbered from 1 to 10 starting from (with DIP switches for serial port hardware configuration the antenna panel side.
  • Page 6 Wireless Gateway 1MRS757424 C RER601/603 Product version: 1.2 Table 1. Description of available LEDs o the side panel LED number LED status Description Batt. LED unassigned Status VPN connection is up Blinking VPN onnection is starting VPN connection is disabled...
  • Page 7 5 Application serial port (RS2) 6 DIP switches 7 I/O extension (only available for RER603) 8 Ethernet connector Antenna panel description Both Wireless Gateways RER601/603 have a SIM card insertion slot with SIM card tray and antenna connector card on the antenna panel.
  • Page 8: Communication

    IEC 60870-5-104 is used to communicate towards a SCADA wireless data transfer speed can be supported if needed, via an approved M2M Gateway (available from ABB) over the however the practical data transfer rates depend on the available customer chosen GPRS/GSM data network. In the...
  • Page 9: Technical Data

    Wireless Gateway 1MRS757424 C RER601/603 Product version: 1.2 5. Technical data Table 2. Dimensions Description Value Width x Height x Depth 45 x 175 x 108 mm (without antenna) Table 3. Hardware Description Value Processor environment Processor 32 bit RISC...
  • Page 10 Wireless Gateway 1MRS757424 C RER601/603 Product version: 1.2 Table 5. Physical interfaces Description Value I/O interfaces (for Wireless Gateway RER603 only) 8 binary inputs 2 binary outputs GUID-9E610926-032D-486F-AB59-CFBF3D85396C V1 EN Figure 6. Front view of RER603 showing the I/O connector pin numbering Table 6.
  • Page 11 Wireless Gateway 1MRS757424 C RER601/603 Product version: 1.2 Table 7. Network interfaces Description Value Ethernet 10/100 Base-T. Shielded RJ-45 1.5 kV isolation transformer Ethernet IEEE 802-3, 802-2 GPRS Bandwidth Quad band (850/900/1800/1900 MHz) Module Internal module and SIM card socket...
  • Page 12 Wireless Gateway 1MRS757424 C RER601/603 Product version: 1.2 Table 7. Network interfaces, continued Description Value Serial Ports Serial 1 / Console RS-232 DTE Male DB-9 connector IEC 60870-5-101 protocol support Full serial and modem signals 300...460 800 bps. Data bits – 7 or 8...
  • Page 13 Wireless Gateway 1MRS757424 C RER601/603 Product version: 1.2 Table 8. Electromagnetic compatibility tests Description Type test value Reference Electrostatic discharge test: EN 61000-4-2 • Contact discharge 4 kV • Indirect contact discharge 4 kV Conducted RF Immunity test: EN 61000-4-6 •...
  • Page 14: Mounting Methods

    Wireless Gateway 1MRS757424 C RER601/603 Product version: 1.2 Table 10. RoHS and REACH compliance Description Complies with RoHS directive 2002/95/EC Complies with REACH directive 2006/1907/EC 6. Mounting methods with appropriate cable. This allows for better positioning of The devices have been equipped with mounting the devices, antennas and thus optimal performance.
  • Page 15 R E R 6 0 1 A 1 A A A G 1 A Your ordering code: Digit (#) 10 11 12 13 14               Code GUID-DD989E03-2DDA-4813-91C1-85B0E21363EF V1 EN Figure 7. RER601 ordering code example...
  • Page 16 Wireless Gateway 1MRS757424 C RER601/603 Product version: 1.2 R E R 6 0 3 A 1 A A A G 1 A DESCRIPTION RER603 Wireless Gateway RER603 Version Power Supply 6 – 26 VDC Inputs and Outputs 8 BI + 2 BO...
  • Page 17: Accessories And Ordering Data

    RER601/603 Product version: 1.2 8. Accessories and ordering data sold device that could have been damaged or lost. ABB does Certain equipment accessories can be attached to the not supply internal components or parts. The external devices to increase the flexibility and/or functionality of the...
  • Page 18: References

    Wireless Gateway 1MRS757424 C RER601/603 Product version: 1.2 GUID-4BEC2B3C-7F54-483E-946F-A4C8D54F7270 V1 EN Figure 9. RER601/603 WebHMI 10. References The download area on the right hand side of the Web page www.abb.com/substationautomation portal offers you contains the latest product documentation. The selection tool...
  • Page 19: Document Revision History

    Wireless Gateway 1MRS757424 C RER601/603 Product version: 1.2 11. Document revision history Document revision/date Product version History A/2011-09-02 First release B/2011-09-29 Content updated C/2014-08-18 Content updated...
  • Page 24 Contact us ABB Oy Medium Voltage Products, Distribution Automation P.O. Box 699 FI-65101 VAASA, Finland Phone +358 10 22 11 +358 10 22 41094 www.abb.com/substationautomation...

This manual is also suitable for:

Rer603

Table of Contents