External Keyboard/Numeric Keypad - microHAM MK2R User Manual

Hide thumbs Also See for MK2R:
Table of Contents

Advertisement

NOTE: The keyboard/Keypad must be PS/2. A USB device with PS/2 adapter will not work properly.
MK2R includes the ability to generate FSK or CW, record and play CW, FSK or VOICE messages using a
PS/2 keyboard or numeric keypad connected to the PS/2 jack. A numeric key pad is sufficient to record
and play CW and DVK messages, control CW speed (WPM) or play a serial number message. "Live" CW
or FSK (RTTY) requires a full keyboard.
Switching modes:
The keyboard or keypad mode will follow the mode of the transceiver with Transmit Focus. If the radio is
not computer controllable or its control protocol is not supported, the keyboard or keypad can be used to
switch Router's operating mode if the "radio" selection is "no radio (mode selected manually)."
Playing messages:
A message is started by pressing F1-F9 on the keypad or 1-9 on the number pad. A message can be
aborted with the ESC key or the zero key on the number pad. Messages may be made to repeat (loop) by
pressing DEL (period) on the number pad while the message is playing. The default (minimum) wait time
after ending a message and starting again is one second. The pause time may be set from 1 to 9 seconds
by entering the desired delay immediately after pressing DEL. For example, 1 <DEL> 5 will start message
number 1 and cause it to repeat with five a second delay. Pressing zero (0) will terminate a message loop.
Recording messages:
Recording is started (and stopped) by pressing NUM LOCK. To start recording, press NUM LOCK followed
by the number of the message to be recorded. To abort a message without saving, press zero on the
number pad or Escape. To end recording and save the message press NUM LOCK.
In CW, MK2R stores characters as they are echoed from the internal WinKey2: only those characters
actually transmitted are stored. However, CW messages may be recorded from either paddles or the
keyboard. The gap "|" and other WinKey commands cannot be entered from the keyboard but may be used
in messages loaded from Router's CW/FSK Messages tab.
In FSK, all characters entered from the keyboard are stored.
microHAM © 2008 All rights reserved
EXTERNAL KEYBOARD/KEYPAD
STATUS INDICATION
NUM CAPS SCROLL play/rec
OFF
x
x
ON
x
x
x
OFF
OFF
x
OFF
ON
x
ON
OFF
x
ON
ON
mode
playback
recording
CW
DIGITAL
FSK
VOICE
70

Advertisement

Table of Contents
loading

This manual is also suitable for:

Mk2r+

Table of Contents