Fsk & 2 - microHAM MK2R User Manual

NOTE: Although Router has been tested extensively using many different applications for the CAT and 2
ports, microHAM cannot guarantee proper operation with every possible combination of software.
The FSK channel is used by the application program to send the FSK keying signal. FSK is used primarily
for RTTY. It is very important to understand the difference between FSK and AFSK.
FSK is a digital (On/Off) signal used in the transceiver to generate a frequency shift. FSK must be
supported by the transceiver (this mode is commonly labeled RTTY or FSK).
AFSK is an analog (audio) signal used to modulate the transceiver for digital modes like RTTY, PSK31,
AMTOR etc. Computer sound card generated AFSK or PSK does not require special transceiver support
and can be used in the LSB, USB or FM mode of the transceiver. Some radios have dedicated modes for
AFSK (generally labeled PKT, DATA, LSB-D or USB-D) with special features.
It is very important to properly adjust the audio drive level of an AFSK system so as to not overdrive the first
transmit audio amplifier stage in the transceiver and produce a wide, distorted signal, full of intermodulation
products. It is important to appreciate that distortion generated at this point due to overdrive CANNOT be
reduced or eliminated by the reduction of the microphone gain control – it is the signal level that must be
adjusted to be about the same as would be expected from a microphone. The microphone gain control then
becomes a form of transmit power control.
An initial indication of proper audio drive level can be seen on the ALC meter of the radio. Provided that
there is NO audio processing in circuit and that the microphone gain control is in its normal operating
position, then, if the ALC does not show or just starts to indicate during transmission, the signal is likely to
be clean. It is also important is to turn off the microphone compressor, ANY transmit audio equalizer, AND
transmit DSP when AFSK is used. DO NOT use any form of digital modulation (sometimes called
"Transmit DSP") with AFSK or PSK. Some transceivers bypass these circuits automatically when signal is
routed to the rear audio jack instead of the microphone jack, but some do not (for example, the TS-850).
If your transceiver supports FSK, use FSK for RTTY whenever possible. It's the only sure way to get
a clean RTTY signal no matter the microphone gain or compressor (processor) settings on your
radio.
When a COM port is assigned in Router but not in the application program (or the application is not
running), Router will indicate the channel is closed.
When an application opens the COM port, Router will indicate the channel is open and display baud rate,
number of data bits, parity and number of stop bits in use. For example, 45 5N1.5 means: 45 Baud, 5 data
bits, no parity, 1.5 stop bits.
The second FSK port is usefull when operating
split with radios that have two receivers (e.g.,
FT-1000, FT-2000, FT-9000, K3, Orion or
IC-7800). The second instance of the RTTY program should specify "right channel" for its audio source and
should be configured to use the 2
nd
The 2 FSK port can also be used for a second RTTY program with a different decoding algorythm to
provide diversity decoding and transmit from either program.
TIP: If you see a baud rate other than 45.5 baud (e.g., 4800 or 9600), the application is NOT
configured correctly for FSK RTTY operation.
microHAM © 2008 All rights reserved
nd
FSK & 2 FSK PORTS
nd
FSK port for its FSK output.
29
Edited by Geoff Anderson, G3NPA
nd
CAT