Panasonic KX-TAW848 Feature Manual page 217

the transfer destination extension to the VPS. Therefore the caller can leave a message in the mailbox
of the extension without knowing the mailbox number. The "Transfer Recall to Mailbox" setting
should be enabled through system programming to use this feature.
→ 2.8.4 [2-3] Timers & Counters—Dial / IRNA / Recall / Tone—Recall—Transfer Recall
→ 2.9.15 [3-7-1] VM(DPT) Group—System Settings—Transfer Recall to Mailbox
→ [201] Transfer Recall Time
6.
Listening to a Recorded Message (Direct Mailbox Access)
If the VPS receives a message, the VPS will set the Message Waiting feature (e.g., turning on the
Message button light on the corresponding telephone as notification. (→ 1.11.3 Message Waiting)
Thereby, the VPS notifies the extension user that there is a message waiting in his mailbox. When the
Message button light turns on, pressing the button allows the extension user to play back the messages
stored in his mailbox without dialing such as a mailbox.
When the extension user dials an extension number of the VM (DPT) extension port or the floating
extension number of the VM (DPT) group from his extension, he can listen to the messages stored in
his mailbox without dialing his mailbox number (Direct Mailbox Access). It is possible to disable this
feature by COS programming on the VPS.
7.
VPS CO Line Service & Automatic Time Mode Notification for Incoming Call*
Multiple tenants can share a single VPS; each tenant does not require a dedicated VPS port. If the
destination of the incoming CO line call is a VM (DPT) group, the PBX sends the VPS trunk group
number and time mode (day/lunch/break/night) of the tenant (→ 1.17.4 Time Service) assigned for the
call to the VPS. Therefore the VPS can send the assigned message (company greeting) to the caller.
Corresponding VPS trunk group number and tenant number are determined by the setting of each CO
line port.
2.15.2 [9-2] DIL Table & Port Settings—DIL
→Tenant Number
→VM Trunk Group
1.19 V
Feature Manual 217