NEC Univerge SV8100 Programming Manual page 169

Digitcom Canada Inc. Need Support? Call 1-866-667-8357 Visit us at: www.digitcom.ca
UNIVERGE SV8100
Programming Manual
Item
Item
No.
20
Block Outgoing
Caller ID
Allow (1) or prevent
(0) the system from
automatically blocking
outgoing Caller ID
information when a
user places a call. If
allowed (i.e. block,
enabled), the system
automatically inserts
the Caller ID block
code (defined in
14-01-21) before the
user dialed digits.
21
Caller ID Block Code
Enter the code, up to
8 digits, that should
be used as the Caller
ID Block Code. This
code is automatically
inserted before dialed
digits if Program
14-01-20 is set to 1.
22
Caller ID to Voice
Mail
Enable or disable the
system ability to send
the Caller ID digits
(Remote Log-On
Protocol) to voice
mail.
23
--- Not Used ---
24
Trunk-to-Trunk
Outgoing Caller ID
through Mode
Enable (1) or Disable
(0) the ability to send
the original Caller ID
through when the call
is Forward Off-
Premise.
Input Data Default
0 = Disable
(No)
1 = Enable
(Yes)
Dial (up to eight
digits)
0 = Disable
(No)
1 = Enable
(Yes)
0 = Disable
(No)
1 = Enable
(Yes)
Issue 1.0
Related
Program
0 14-01-21
67 14-01-20
0
0
2 - 135