Dehumidifying - Mitsubishi Electric MJ-E15BX-A1 Instruction Manual

Dehumidifying

You can select from three operating modes.
1
Press
The operating mode lamp lights.
The current humidity is displayed.
The louvre opens and airfl ow starts.
2
Press
operating mode
Changes with every press.
Use the swing louvre as desired.
To stop operation
Press
14
to select the
P16
The operating mode lamp turns off.
The CURRENT HUMIDITY indicator goes out.
The louvre closes.
Operation stops after air is blown from the
back air outlet for approximately 2 minutes.
2 1
The compressor does not activate immediately after
turning the unit off, or after plugging the unit into the
power socket. (This is in order to protect the compressor.)
Dehumidifying begins approximately 3 minutes after
you press the POWER switch. When dehumidifying
begins, the operational noise increases.
The unit records the operating mode. Even if the plug is
disconnected or the power turned off, the unit restarts at
the previous setting.
AUTO
DEHUMIDIFYING
The unit changes the airfl ow rate automatically and
operates intermittently. Select this when you want to
maintain a comfortable humidity level.
Rough Guide on Usage
Size of room Up to approx. 13m
Keep usage within the ranges specifi ed in "Rough
Guide on Usage" to ensure effi cient operation.
HIGH
DEHUMIDIFYING
The unit operates continuously with a high airfl ow rate.
Select this when you want to dehumidify at a high
level.
LOW
DEHUMIDIFYING
The unit operates continuously with a low airfl ow rate.
Select this when you want a reduced air fl ow during
dehumidifying.
If the room temperature exceeds 35°C, the unit
operates with the same airfl ow rate as HIGH in
order to protect the compressor.
To prevent the temperature inside
the unit from rising, the blower
fan rotates for approximately 2
minutes before operation stops.
Wait until the blower fan stops
before unplugging the power cord.
If the Internal drying operation
(auto) is set, it starts after
operation stops.
2
P19