Mitsubishi Electric MJ-E15BX-A1 Instruction Manual page 23

Once Every Three Months
Silver Ion Filter (Soak in Water)
Soaking the silver ion fi lter in water enables you to remove fi ne dust and odour from the silver ion fi lter.
Preparation
Press the POWER switch to turn off the
power, wait until the blower fan stops rotating
(approximately 2 minutes) before unplugging the
power cord.
1
Remove the fi lter cover
Removing the fi lter, see P22
Remove the silver ion fi lter
2
from the fi lter cover, and then
clean the fi lter.
Remove any dust from the white net
surface with the nozzle of a vacuum
cleaner.
Do not use a nozzle with a brush. This may
damage the fi lter.
Silver ion fi lter
Filter cover
Soak the silver ion fi lter in
3
water.
Do not use detergent or hot water. Also,
do not use a brush or the like to scrub the
fi lter or rub the fi lter while soaking. This may
damage the fi lter.
Any yellow or dark stains may remain on the
fi lter, but should not affect performance.
The fi lter can be soaked for a total of eight
times. After that, replace with a new fi lter.
4
Dry the silver ion fi lter well
Do not hang with pegs or the like. This may
damage the fi lter.
Do not use the fi lter while wet.
Set the silver ion fi lter into
5
the fi lter cover
Setting the fi lter, see P22
6
Set the fi lter cover.
Setting the fi lter, see P22
Soak in cool to
lukewarm water for
about 30 minutes.
Dry the fi lter on an
even surface in the
shade.
23