Dehumidifying - Mitsubishi Electric MJ-E100AR-H Instruction Manual

Dehumidifying

The operation mode can be selected accordingly to the situation.
2 2
1
Press
z POWER lamp lights.
z The operation mode is displayed.
z Louvre opens, and blows air.
2
Select the operation mode.
<To select the dehumidifying mode and operate>
Press
<To set the humidity and operate>
Press
3
Press
<To stop operation>
Press
z POWER lamp goes out.
z The operation mode indicator goes out.
z The dehumidifier remembers the operation mode. Even if the power plug is disconnected or the power is turned off, the
unit restarts at the previous setting.
z The humidity cannot be set in modes other than "AUTO".
z Operation stops when the tank is full. To restart operation, remove water from the tank. If a continuous drainage hose is set,
the dehumidifier will operate continuously.
z In the case of a power outage during operation, the dehumidifier will restart operation upon restoration in the operation
mode before the power outage.
z If the DRYING INSIDE (auto) operation has been activated, the DRYING INSIDE operation will start after the unit stops.
P18
12
3 1
Blip
to begin operation.
P13–14 z The operation mode switches each time the button is pressed.
Blip
P13
z The set humidity changes each time the button is pressed.
Blip Blip
70 65
and select the swing direction.
Blip
P20
Blip
Blip Blip Blip Blip
60 55 50％
P16
Blip Blip Blip Blip