Lubricating Machine; Maintenance; Replacing The Scraper; Replacing The Rotor - Toro 1800 Power Curve Operator's Manual

Maintenance

NOTICE! All electrical repairs should be performed by an
Authorized Service Dealer only.
Note: Determine the left and right sides of the machine from the
normal operating position.
WARNING
If the extension cord is plugged into the machine, someone
could accidentally operate the machine while you are performing
maintenance on it, causing serious personal injury.
Remove the key and disconnect the extension cord before you
perform any maintenance on the machine.
Lubricating the Machine
You do not need to lubricate the machine; all the bearings have been
lubricated at the factory for the life of the machine.

Replacing the Scraper

The scraper is located at the bottom of the rotor housing as shown in
Figure 12.
1. Scraper
1. Remove the screw from each side plate that holds the scraper
(Figure 13) and 2 screws from under the machine (Figure 14) that
secure the scraper to the machine.
1. Screw (2)
Figure 12
Figure 13
1. Screws
2. Remove and discard the old scraper.
3. Install the new scraper, and fasten it securely with the 4 screws
that you previously removed.

Replacing the Rotor

1. Remove the screws that secure the right side plate to the machine
frame (Figure 15).
2. Remove the rotor pin (Figure 16).
1. Rotor pin
3. Remove the old rotor.
8
Meijer.com
Figure 14
Figure 15
Figure 16