Installing The Chute Control Rod; Installing The Upper Handle - Toro 1800 Power Curve Operator's Manual

Setup
Note: Determine the left and right sides of the machine from the
normal operating position.

Installing the Upper Handle

1. Remove the handle knobs, oval bolts, and curved washers from
the lower handle.
2. Install the upper handle to the lower handle of the machine with
the handle knobs, curved washers, and oval bolts as shown in
Figure 1.
1. Handle knob (2)
2. Curved washer (2)
3. Oval bolt (2)
Note: Ensure that the power cord attached to the machine is
routed over the lower handle and to the inside of the handle
assembly.
3. Tighten the handle knobs firmly by hand.
4. Attach the cord guide to the handle (Figure 2).
1. Cord guide
2. Handle
Figure 1
4. Lower handle
5. Upper handle
Figure 2
3. Cord

Installing the Chute Control Rod

1. Position the discharge chute so that it faces forward.
NOTICE! Align the arrow on the discharge chute with the
arrow on the housing (Figure 3).
1. Discharge chute
2. Insert the end of the chute control rod through the keyed hole in the
bracket that is attached to the top of the lower handle (Figure 4).
1. Keyed hole
3. Remove the decal that covers the keyed hole in the back of the
housing (Figure 5).
4
Meijer.com
Figure 3
2. Align the arrows
Figure 4
2. Bracket