Advertisement

1800 Power Curve
Model No. 38381—Serial No. 319000001 and Up
If, after carefully reading this manual, you still have questions
or problems, call toll free 1-800-808-2963 (US) or 1-800-808-3072
(Canada) before returning this product.
You may contact Toro directly at www.Toro.com for product
and accessory information, help finding a dealer, the complete
warranty details, or to register your product.
WARNING
CALIFORNIA
Proposition 65 Warning
The power cord on this product contains
lead, a chemical known to the State
of California to cause birth defects
or other reproductive harm. Wash
hands after handling.
Use of this product may cause exposure
to chemicals known to the State of
California to cause cancer, birth defects,
or other reproductive harm.
IMPORTANT SAFETY
INSTRUCTIONS
When using an electrical appliance, basic precautions should
always be followed, including the following:
READ ALL INSTRUCTIONS
BEFORE USING THIS APPLIANCE
WARNING
To reduce the risk of fire, electric
shock, or injury, follow these safety instructions.
It is essential that you or any other operator of the appliance
read and understand the contents of this manual before operating
the appliance. Pay particular attention to the safety alert symbol
which means CAUTION, WARNING, or DANGER—personal
safety instruction. Read and understand the instruction because it
has to do with safety. Failure to comply with these instructions
may result in personal injury, risk of fire, or electrical shock.
Double insulation—The power cord and switch used on this
machine cannot be replaced, and the equipment shall be disposed
of.
Do not use the appliance on graveled surface unless it is adjusted
for such a surface in accordance with the Operator's Manual.
© 2019—The Toro® Company
8111 Lyndale Avenue South
Bloomington, MN 55420
®
Snowthrower
Keep children and bystanders away—All visitors should be kept
at a distance from the work area.
Dress properly—Do not wear loose clothing or jewelry. They
can be caught in moving parts.
Wear rubber boots when operating the appliance.
Operating the appliance in the hand-held position is unsafe,
except in accordance with the special instructions for such use
provided in the Operator's Manual.
Warning—To prevent electric shock, use the appliance only with
an extension cord suitable for outdoor use.
Extension cords—To prevent the appliance cord and the
extension cord from disconnecting during operation, connect the
extension cord to the appliance as shown in
Avoid accidental starting—Do not carry the appliance with your
finger on the switch. Ensure that the switch is off when plugging in
the appliance.
If the appliance cord is damaged in any manner while it is plugged
in, disconnect the extension cord from the wall receptacle and
contact an Authorized Service Dealer.
Do not abuse the cord—Never carry the appliance by its cord or
yank on the extension cord to disconnect the appliance from the
receptacle. Keep the cord from heat, oil, and sharp edges.
Keep hands away from moving parts.
Keep guards in place and in working order.
Do not force the appliance—It will perform better and safer at
the rate for which it was designed.
Do not overreach—Watch your footing and keep your balance
at all times.
If the appliance strikes a foreign object, follow these steps:
Disconnect the appliance—Disconnect the appliance from the
power supply when not in use, before servicing, when changing
accessories, etc.
Store an idle appliance indoors. When the appliance is not in
use, it should be stored indoors in a dry, secured place out of the
reach of children.
Maintain the appliance with care—Follow instructions for
changing accessories.
Register at www.Toro.com.
Immediately release the control bar to stop the appliance.
Unplug the power cord.
Inspect for damage.
Repair any damage before starting and operating the
appliance.
Original Instructions (EN)
All Rights Reserved *3424-703* B
Printed in the Mexico
Form No. 3424-703 Rev B
Operator's Manual
Figure
9.

Advertisement

Table of Contents
loading

Summary of Contents for Toro PowerCurve 1800

  • Page 1 1-800-808-2963 (US) or 1-800-808-3072 (Canada) before returning this product. You may contact Toro directly at www.Toro.com for product Keep children and bystanders away—All visitors should be kept and accessory information, help finding a dealer, the complete at a distance from the work area.
  • Page 2: Clearing A Clogged Discharge Chute

    • This appliance meets or exceeds the B71.3 specifications If the appliance should start to vibrate abnormally, stop the of the American National Standards Institute in effect at the motor and check immediately for the cause. Vibration is time of production. generally a warning of trouble.
  • Page 3: Safety And Instructional Decals

    SAVE THESE INSTRUCTIONS Safety and Instructional Decals Safety decals and instructions are easily visible to the operator and are located near any area of potential danger. Replace any decal that is damaged or missing. decal138-6679 138-6679 1. Warning—read the 3. Cutting/dismemberment Operator’s Manual.
  • Page 4: Installing The Upper Handle

    Setup Note: Determine the left and right sides of the machine from the normal operating position. Installing the Upper Handle Remove the handle knobs, oval bolts, and curved washers from the lower handle. Install the upper handle to the lower handle of the machine with the handle knobs, curved washers, and oval bolts as shown in Figure...
  • Page 5 g013477 Figure 4 1. Keyed hole 2. Bracket Remove the decal that covers the keyed hole in the back of g021775 the housing (Figure Figure 6 1. Handle on the chute control rod Firmly push the rod into the keyed hole in the back of the housing until it snaps into place.
  • Page 6: Operation

    Operation DANGER Contact with water while operating the machine could cause electric shock, causing injury or death. Product Overview • Do not handle the plug or the machine with wet hands or while standing in water. • Use only an extension cord recommended for outdoor cold-weather use.
  • Page 7: Starting And Stopping The Motor

    Starting and Stopping the Adjusting the Discharge Chute and Chute Deflector Motor To start the motor, insert the interlock button (key), press To adjust the discharge chute, move the handle on the chute and hold the interlock button (key), and squeeze the power control rod in the direction that you wish to direct the snow stream control bar to the handle (Figure...
  • Page 8: Operating Tips

    Operating Tips Maintenance Note: Determine the left and right sides of the machine from WARNING the normal operating position. If the machine hits an object while in operation, the object could be thrown at you or bystanders, resulting WARNING in serious personal injury. If the extension cord is plugged into the appliance, Keep the area to be cleared free of all objects that the someone could accidentally operate the appliance...
  • Page 9: Replacing The Rotor

    Remove the old rotor. Install the new rotor by inserting the end of the rotor onto the fitted end in the housing and rotating the rotor until it snaps into place (Figure 17). g013469 Figure 14 1. Screws Remove and discard the old scraper. Install the new scraper, and fasten it securely with the 4 screws that you previously removed.
  • Page 10: Double-Insulated Appliances

    Service Storage Toro has designed this machine to give you years of trouble-free Run the appliance for a few minutes and wipe away any use. Should it need service, bring the machine to an Authorized melted snow on the appliance.
  • Page 11 While the exposure from Toro products may be negligible or well within the “no significant risk” range, out of an abundance of caution, Toro has elected to provide the Prop 65 warnings. Moreover, if Toro does not provide these warnings, it could be sued by the State of California or by private parties seeking to enforce Prop 65 and subject to substantial penalties.

This manual is also suitable for:

38381

Table of Contents