Call Forwarding; Using Variable Call Forwarding - Siemens HiPath 500 Operating Instructions Manual

Step by Step
or

Call Forwarding

Using Variable Call Forwarding

You can immediately forward internal or external calls to
different internal or external telephones (destinations).
(External destinations require special configuration in
the system).
Special features must be taken into consider-
ation if your telephone operates with
HiPath 5000 (system networking via PC net-
work)
n
Lift the handset.
Enter the code.
or Enter the line type you wish to use:
1 = all calls, 2 = external calls only, 3 = internal calls
only
o w
Enter the destination number (without the external
code).
Deactivating call forwarding:
n
Lift the handset.
w
Enter the code.
When call forwarding is active, a special dial tone
sounds when you lift the handset.
If DID DTMF is active (contact the service per-
sonnel), you can also forward calls to this desti-
nation. Destinations: fax = 870, DID = 871,
fax DID = 872.
Page 48!
Call Forwarding
29