Siemens HiPath 500 Operating Instructions Manual page 13

Step by Step
Speaking to visitors via the entrance telephone:
Precondition: Your telephone rings.
n
Lift the handset within thirty seconds. You are connect-
ed to the entrance telephone immediately.
or
n
Lift the handset after more than thirty seconds.
o
Dial the entrance telephone number.
Opening the door from your telephone during a call
from the entrance telephone:
Enter the code.
o w
Dial the entrance telephone number.
Special features must be taken into consider-
ation if your telephone operates with
HiPath 5000 (system networking via PC net-
work)
Opening the door with a code (at the door):
o
After ringing the bell, enter the five-digit code (using the
keypad or a DTMF transmitter). Depending on how the
door opener has been programmed, a doorbell call
signal may or may not be forwarded.
Activating the door opener:
n
Lift the handset.
Enter the code.
o
Dial the entrance telephone number.
o w
Enter the five-digit code. Default code = "00000"
(contact the service personnel).
or Enter the type of door opener. 1 = enable with ring,
2 = enable w/o ring = You can also open the door with-
out a doorbell ring.
Deactivating the door opener:
n
Lift the handset.
Enter the code.
o w
Dial the entrance telephone number.
Making and Answering Calls
Page 52!
13