GE TransNET 900 Reference Manual page 95

Programming radio 28–44
as root or node 49
PWR command (set/display RF forward output power) 38
R
Radio
inoperative (troubleshooting chart) 48
no synchronization with master (troubleshooting chart) 48
poor performance (troubleshooting chart) 48
Radio Operating Mode (MODE) Command 36, 37
Radio Receive Test Frequency Command (RX) 39
Radio Serial Number Command (SER) 40
Radio Transmit Test Frequency (TX) 43
Radio Transmitter Hop Timing (HOPTIME) 34
Radio Transmitter Power Level (PWR) Command 38
Radio's Internal Temperature Command (TEMP) 43
Radio-MODEM Behavior (DEVICE) Command 32
Receive Data Timeout-Timer Command (RXTOT) 40
Received Signal Strength Indicator Command (RSSI) 38
Remote radio
default settings 34
Remote station
typical arrangement, illustrated 6
Remote Terminal Unit Simulator Command (RTU) 39
Repeater Operation. See Store-and-Forward (SAF)
Restore to Factory Defaults (INIT) 34
RJ-11
Diagnostic Interface, Connection 69
Root (radio diagnostics type) 33, 50
RSSI command (display received signal strength) 38
RTU command (enable/disable internal RTU) 39
RX command (set/display test receive frequency) 39
RXD Command 39
RXD Delay Command (RXD) 39
RXTOT command (set/display received data timeout value) 40
S
SAF command (store-and-forward) 40
Security
Network Address 65
optional encryption value 65
Security Code (CODE) Command 31
Security, Data 65
SER Command 40
Set
alarm output sense (ASENSE command) 29
alarm output signal (AMASK command) 29
CTS hold timer (CTSHOLD command) 32
CTS line response timer (CTS command) 31
data interface baud rate (BAUD command) 29
MDS 05-2708A01, Rev. F MDS TransNET Ref. Manual I-7