Xaddr [0-31]; Extended Address; Xmap [00000000-Ffffffff]; Map Of Extension Addresses - GE TransNET 900 Reference Manual

XADDR [0–31]

Extended Address

Used to display or program the Extended Address of this radio that will serve
as a common address for the sub-network synchronized to this Master or
Extension. This value can be listed in the
sion or Remote radios to allow them to synchronize to this radio. We recom-
mend setting the Master to zero (0). It is easy to remember, and is the default
address when the INIT command is used. (Programmed only in Master and
Extension radios.)

XMAP [00000000-FFFFFFFF]

Map of Extension Addresses

XMAP is a 32-bit hex entry where the least significant bit represents XADDR
0 and the most significant bit represents XADDR 31. The full 32-bit hex
value represents the entire list of extensions with which the radio will be
allowed to communicate. (Pertains to Remotes and Extensions only.)
This parameter is easily programmed through the MDS TransNET Configu-
ration Software's
XPRI [0–31]

Primary Extended Address

Will display or program the extended address of the primary radio with which
this radio will attempt to synchronize and communicate. A setting of
allows the unit to synchronize with any Master or Extension in the
(Parameter only meaningful for Remote or Extension units.)
XRSSI [NONE, –40...–120]

Extension RSSI Level

The XRSSI command is used to set the RSSI minimum signal level required
to preserve synchronization with a non-primary Extension radio. This param-
eter will be ignored if

ZONE CLEAR

Clear Zone Statistics Log

The
ZONE CLEAR
Data Log, resetting the count to 0. (Zone data is also cleared automatically
upon reboot.)

ZONE DATA

Read Zone Statistics Log

The transceiver divides its frequency operating spectrum into eight
3.0 MHz-wide zones or sub-bands. (These are the same zones referenced by
the command described earlier.) Data frame statistics are maintained for
SKIP
each zone to indicate the transmission quality of data through the network.
This information is useful for identifying zones where significant interference
exists.
44 MDS TransNET Ref. Manual
Store-and-Forward Settings
is set to
XPRI
command clears the zone data for all zones in the Zone
parameter of associated Exten-
XPRI
panel.
.
NONE
MDS 05-2708A01, Rev. F
NONE
list.
XMAP