Radio Operating Mode; Mrssi [None, -40; Minimum Rssi For Mobile Operation; Ot [On, Off] - GE TransNET 900 Reference Manual

All units default to Remotes; other modes must be specifically programmed
with the command.
MODE
If is used, the
MODE X
Extended Address (
be programmed with an appropriate
MRSSI [NONE, –40...–90]

Minimum RSSI for Mobile Operation

The command sets or displays the minimum RSSI level (dBm) of a
MRSSI
Master station's signal to maintain synchronization. When the Master's
signal falls below this level, the Remote will attempt to resynchronize with
the next Master it can hear within the same network—same Network Address
( )—and, meets the MRSSI level. See
ADDR
Page 62 for additional information.

OT [ON, OFF]

Output Trigger

The "output trigger" feature sets up a 1-second default delay on delivery of
RXD serial data, however, a receipt of RTS causes cancellation of timer
followed by immediate data delivery.
Hierarchy Rules:
• if = ON, RTS always cancels data delay and outputs immediately
OT
• if = ON,
OT
until RTS
• if = DCE, and
DEVICE
• if = CTS KEY, and
DEVICE
• if = CTS KEY overrides
DEVICE

OWM [xxxxx]

"Owner's Message"

The command sets or displays an optional owner's message, such as the
OWM
system name. The entry can contain up to 30 characters.

OWN [xxxxx]

"Owner's Name"

The command sets or displays an optional owner's name, such as the
OWN
site name. The entry can contain up to 30 characters.

PORT [RS232, RS485]

Data Interface Port Signaling Standard

Select or identify the current data port (
mode: or
RS232 RS485
MDS 05-2708A01, Rev. F
radio should be programmed with an
MODE X
). Units that need to hear this
XADDR
= DCE, and
DEVICE
= N, data delay is N ms
RXD
CTS
. This is the port though which the payload data will
MDS TransNET Ref. Manual
and/or
XPRI XMAP
"Mobile Operation Support" on
= 0, data delay is 1 second or
RXD
= N, data delay is N ms or until RTS
, overrides
RXD RXD
DATA
connector) interface signaling
radio must
MODE X
value.
default.
OT
37