Using The I/O Points With Insite™ Nms Software; Application Example-Digital I/O At A Remote - GE TransNET 900 Reference Manual

Table 29. TransNET User I/O Connection Resources
Data Interface Pin
DB-9, Pin 9
RJ-11, Pin 1
RJ-11, Pin 2
RJ-11, Pin 3
a. Configuration and data retrievable via MDS InSite™ software as "I/O 1"
b. Configuration and data retrievable via MDS InSite™ software as "I/O 2"
c. Parameter retrievable via MDS InSite™ software
Using the I/O Points with InSite™ NMS Software
InSite software has the ability to read the user analog input (
user-configurable and independent I/O signals (
connection can independently configured as input or output. If configured as
an output, a saved default output value can be stored in the radio to ensure the
radio boots to the desired state for this pin.
The values of
I/O 1
determine the current state. The values of
DATA
Interface connector will remain in a constant state until manually
changed though the InSite
Application Example—Digital Input and Output at a Remote
A typical application of the user I/O connections may require one digital input
and one digital output to be controlled by network diagnostics. In this
H3
example, could be jumpered to
H8
to (I/O 2 to RJ-11, Pin 2). Using InSite,
output and as an input.
I/O 2
MDS 05-2708A01, Rev. F
& can be read and displayed by an InSite user to
I/O 2
Configuration
H7
MDS TransNET Ref. Manual
I/O 1 & I/O 2
&
I/O 1 I/O 2
screen.
(I/O 1 to RJ-11, Pin 1) and
could be configured as an
I/O 1
Available
at eyelet:
H1
H7
H8
H9
) and two
Analog 1
). Each I/O
at the TransNET's
H4
jumpered
75