Ctshold [0-60000]; Clear-To-Send Hold Time; Device [Dce, Cts Key]; Radio-Modem Behavior - GE TransNET 900 Reference Manual

For CTS Key operation (see the
long to wait after asserting the CTS line before sending data out the
port. A timer value of zero means that data will be sent out the data port
without imposing a key-up delay. (Other delays may be in effect from other
radio operating parameters.)
CTSHOLD [0–60000]

Clear-to-Send Hold Time

Used in
DEVICE CTS KEY
milliseconds that CTS remains present following transmission of the last
character out the RXD pin of the
prevent squelch tail data corruption when communicating with other radios.
The setting can range from 0 to 60000 (i.e., 60 seconds). The
CTSHOLD
default value is 0, which means that CTS will drop immediately after the last
character is transmitted. If the command is entered when the radio is in
mode, the response
DEVICE DCE

DEVICE [DCE, CTS KEY]

Radio-MODEM Behavior

The command sets or displays the device behavior of the radio. The
DEVICE
command parameter is either
The default selection is
subject to the CTS programmable delay time. Keying is stimulated by the
input of characters at the data port. Hardware flow control is implemented by
dropping the CTS line if data arrives faster than it can be transmitted.
If is selected, the radio is assumed to be controlling another radio,
CTS KEY
such as in a repeater or tail-end link system. The RTS line is ignored and the
CTS line is used as a keyline control for the other radio. CTS is asserted
immediately after the receipt of RF data, but data will not be sent out the
DATA
port until after the CTS programmable delay time has expired. (This
gives the other radio time to key.)
Following transmission of the last byte of data, CTS will remain asserted for
the duration specified by the
sufficiently high.

DLINK [xxxxx/ON/OFF]

InSite Diagnostics Link Support
enables use of Diagnostic Link mode and establishes it as the
DLINK ON
default protocol on the RJ-11
protocol used to support Network-Wide Diagnostics.
to support connection to InSite or to support chained diagnostics between
ON
radio networks even while the radio is in sleep mode.
feature. The default setting is
32 MDS TransNET Ref. Manual
command), the timer specifies how
DEVICE
mode, this command sets the amount of time in
DATA
port. This "hold time" can be used to
CTSHOLD N/A
or
DCE CTS KEY
. In this mode, CTS will go high following RTS,
DCE
command.
CTSHOLD
DIAG
port. Diagnostic Link mode is a special
.
ON
will be displayed.
.
should be set
CTSHOLD
must be set to
DLINK
disables this
DLINK OFF
MDS 05-2708A01, Rev. F
DATA