Table of Contents
Advertisement
CONNECTING TO THE D.20 RIO FOR THE FIRST TIME
Connecting to the D.20 RIO for the first time
To connect to the D.20
RIO
36
To perform the initial set up of the D.20 RIO, you need to plug directly into the D.20 RIO
through the RS-232 port. This port provides a local connection and terminal session with
the D.20 RIO and is used to perform system administrative and maintenance procedures.
Microsoft Windows™ HyperTerminal can be used for terminal emulation but it is NOT
recommended because code and configuration file download times are considerably
increased.
The program Tera Term for Microsoft Windows™ does not have these limitations and is
therefore recommended as a terminal emulation program. It can be downloaded from the
Internet.
1.
Connect the supplied null modem cable (GE part number 977-0529) to your
computer's serial communications port and to the D.20 RIO RS-232 port.
2.
Open the Tera Term terminal emulator application.
Result: The Tera Term: New connection window appears.
3.
Select a Serial connection and click OK.
4.
From the Setup menu, select Serial port....
Result: The Tera Term: Serial port setup window appears.
5.
Select the following options, and then click OK:
Port ................................................................ COM1 (or select another port if required)
Baud rate .................................................... 115200
Data bits...................................................... 8
Parity............................................................. None
Stop bits....................................................... 1
Flow control............................................... None
6.
From the Setup menu, select Terminal....
Result: The Tera Term: Terminal setup window appears.
7.
Select the following options, and then click OK:
Terminal ID................................................. VT 100
8.
Save the Tera Term communications settings.
8.1.
From the Setup menu, select Save setup....
Result: The Tera Term: Save setup window appears.
8.2.
Type in a File Name and click Save.
Result: The configuration .ini file is saved.
The saved setup file can be accessed later: from the Setup menu, select Restore
setup....
9.
In the main terminal window, press Enter.
Result: The D.20 RIO login prompt appears.
10. Type the default username root and press Enter.
11. Type the default password geroot and press Enter.
When you enter the password, it is not visible on the screen.
Result: The D20RIO#>> command prompt appears. You are now online with the D.20
RIO.
GE Information
CHAPTER 4: SETTING UP THE D.20 RIO
D.20 RIO - HARDWARE USER'S MANUAL
Advertisement
Table of Contents
