Nokia IP200 Series Installation Manual page 44

3
Performing the Initial Configuration
Note
For information about how to use the boot manager, see
"Using the Nokia IPSO Boot Manager."
After some miscellaneous output appears, the following prompt appears:
Hostname?
If the Hostname? prompt does not appear on the console, check the
console port and console display connections to ensure that the serial
cable is completely plugged in at both ends. If you verify the console
connections and still do not see either the BOOTMGR> or Hostname?
prompts, verify that the terminal or terminal emulator program settings
are correct. If the settings are correct, contact your Nokia service provider
as listed in
2. Respond to the Hostname? prompt within 30 seconds to prevent the
DHCP client from starting.
If the DHCP client starts and you have already connected to a network
interface, a DHCP server on your network might configure the appliance
with an incorrect host name and IP address (this could happen if a DHCP
server on your network is configured to respond to any request). To reset
the incorrect host name and IP address:
a. Establish a console connection to the system.
b. Enter the following:
c. Reboot the appliance.
d. Respond to the Hostname? prompt within 30 seconds to prevent the
3. At each subsequent prompt, enter the requested configuration
information.
44
"Nokia Contact Information"
rm /config/active
or
mv /config/active /config/active.old
DHCP client from restarting.
Nokia IP200 Series Security Platform Installation Guide
Chapter 7,
on page 3.