HP Z400 Maintenance And Service Manual page 93

NOTE: The metal bracket where the sensor resides is part of the sensor kit and must be installed
before installing a sensor for the first time. Installing a front fan or some full-length expansion cards may
require that you install a front fan holder/card guide instead of the mounting bracket. See
front fan assembly on page 104
assembly.
1. Power down the workstation (see
2.
Disconnect power from the workstation (see
3.
Remove the side access panel (see
4. Install the sensor by sliding the sensor into the slot provided for it in the fan holder/card guide (1),
as shown in the following illustration.
Figure 5-7
5.
Carefully route the sensor cable along the bottom of the drive bay so that it is not pinched by the
fan holder/card guide and plug the sensor cable into the HSENSE connector on the system board
(2).
CAUTION:
NOTE:
6. Make sure that the cable will not interfere with the expansion cards.
ENWW
for details on installing the side access panel sensor with the fan
Installing the side access panel sensor (fan holder mounting)
Clamping a cable between the card guide and the chassis might damage the cable.
To locate system board components, see the service label on the side access panel.
Predisassembly procedures on page
Predisassembly procedures on page
Removing the side access panel on page
Removing and installing components
Installing the
75).
75).
78).
81