HP Z400 Maintenance And Service Manual page 174

6.
On the back of the front bezel, squeeze the HP logo mounting tabs (1), and then press the logo
outward (2), as shown in the following figure.
Figure 5-87
Rotate the HP logo 90 degrees counterclockwise, and then release the logo and press it back into
place in the front bezel.
7. Remove the EMI filler panels and remove the optical disk drive from the chassis (see
optical disk drive from the optical bay (mini-tower configuration) on page
162 Chapter 5 Replacing components
Rotating the HP logo
Removing an
89.
ENWW